Based on equivalent four - terminal networks of the longitudinal ultrasonic transformer , the resonant frequency equation and the amplitude magnification coefficient , with reactive load , are studied 摘要在負載為純力抗的狀況下,利用縱振型變幅桿等效四端網絡,對頻率方程和放大系數進行了研究。
The power - electrical impedance equivalent circuit of each separate module is analyzed and more concise designing rule is educed from it by connecting corresponding four - terminal network in series and taking the material and section area of the separate module as variable 本文分析了各分離組件的力電阻抗等效電路,并將對應的四端網絡相互串聯,以分離組件的材料和截面積為變量,經過分析得出具有分離組件的振動件不管材料是滯相同,設計時均可將多個分離口組件看為一個體的設計規律。
Based on the transfer - matrix method , the general expressions of equivalent four - terminal network parameters of varying section torsional horn are derived , the relations between frequency equation and both the rotational velocity amplification and that of the surface tangential velocity of stepped type torsional ultrasonic horn with transitional section of cosine - like type are obtained 摘要基于傳遞矩陣算法,推導出了變截面桿扭轉振動時等效四端網絡參量的一般表達式,研究了帶類余弦過渡段階梯形變幅桿扭轉振動頻率方程與角速度放大倍數及外表面切向速度放大倍數等的關系。
This paper describes a reconstructive algorithm which is based on network theory for electrical capacitance tomography technic . there are twelve electrodes in the system . the permittivity distribution of flow with two components within a pipeline is reconstructed . assume the permittivity distribution of the region to be reconstructed . then whole measured area is discretized into a network composed of capacitance . the measurement circuit which contains a pair of source electrode and detecting electrode is taken as a four - terminal network . the across admittance of the four - teminal network is proportional to the capacitance between the source electrode and the detecting electrode . modify the distribution of the permittivity according to the difference between the calculated capacitance and measured capacitance . the experimental results show that this algorithm is effective and can coverge 本文描述了一種用于兩種成份的流體成像的12電極電容層析成像新方法.該方法基于電路的網絡理論,首先對重建區域假定一個介電率分布,用電容網絡作為離散化模型,將每一個源電極和探測電極對組成的測量電路看作一個四端網絡,該四端網絡的跨導與源電極和探測電極之間的電容值是線性關系,這個電容值和測量得到的電容值之間存在誤差,根據這個誤差對修正介電率分布.通過對不同介質分布作的模擬實驗結果,證實了該算法是有效的,收斂的